Step 1: Wrap your Magnetic Therapy Bracelet around your wrist to determine the number of links to remove for your perfect fit.

Step 2: Locate the rounded end of the needle on the bracelet side, which will be slightly indented. This is where you need to apply the tool push pin to drive out the needle.

Step 3: Open the sizing tool and lay your bracelet over it. Align the tool push pin with the bracelet needle you wish to remove. It’s easiest to remove links from the middle section of the bracelet.

Step 4: Once aligned, hold the bracelet in place with one hand and gently twist the knob of the sizing tool with your other hand until the needle is pushed out.

Step 5: Twist the knob in the opposite direction to release the bracelet and finish pulling the needle out with your fingers.

Step 6: Repeat this process to remove the desired number of links. Note: you don’t need to remove each link individually.

Step 7: Reconnect the links by placing the rounded end of the needle back in with your fingers, aligning the two bracelet links. Ensure you insert the correct side of the needle (smaller rounded end first).

Step 8: Push against the base of the sizing tool or a hard surface to ensure the pin goes back in flush with the bracelet. If needed, use pliers to press the pin fully. Extra pin-heads are included in the base of the tool for your convenience.

By following these steps, you can easily adjust your Magnetic Therapy Bracelet for a comfortable and secure fit.